Measure the clutch pedal to see if it falls within the Honda Prelude specifications. Pump the clutch pedal a few times to restore the hydraulic pressure. If the fluid level is low, fill it to the recommended level. The reservoir is located on the left of the engine bay near the firewall. How to Adjust the Clutch in a Honda PreludeĬheck the level of the clutch fluid when attempting to adjust the clutch in the Honda Prelude. Measure and note a corresponding change in the clutch pedal disengagement height. The tip of the clutch pedal arm underneath the steering column should have 0.12 to 0.16 inches of free play if adjusted correctly. Adjust the clutch pedal until the free play zone measures 0.6 to 0.8 inches. Turn the adjuster nut with an open-faced wrench. The adjuster nut will be the nut closest to the back end of the vehicle. Approximately half way to the top of the pedal arm will be the adjuster nut assembly. Locate the clutch cable adjusting nut by following the clutch pedal arm up and underneath the steering column. Measure this free play zone distance with a ruler as accurately as possible and write it down. The pedal should have a free play zone where there will be little to no mechanical resistance. Take the pedal between your thumb and pointer finger and play with the pedal up and down. Get an approximation and note it on a piece of paper for reference. Depress the clutch pedal with your hand and measure the height between the pedal and the angled floor board behind the pedal.
0 Comments
Leave a Reply. |